Table of Contents
Advertisement
Site Preparation Guide
5. Remove all tape and carefully unwrap the printer by pulling the plastic bag downward.
6. Using a utility knife, cut away and remove the plastic bag's material ensuring that the bag is
not blocking the fork lift opening or the printer's feet
7. Remove the protective film from the touchscreen and the logos on the printer's exterior.
8. Inspect the printer's exterior for dents and scratches. Immediately report any damage to
Stratasys and the shipping company.
9. Using a forklift, carefully raise the printer vertically and remove the shipping base
20 inches [51cm] Max
Opening for forks
Caution:
Use care when cutting the plastic bag to avoid scratching the printer's surfaces.
Caution:
Access the fork lift opening beneath the printer, between the feet
Figure 5: Opening for Forks
20 inches [51cm] Max
Opening for forks
Preparing For Installation
(Figure
5).
(Figure
.
5).
Page 10
Advertisement
Table of Contents
