Aruba 6000 Series Installation And Getting Started Manual page 19

The screws supplied with the switch are the correct threading for standard EIA/TIA open 19-inch racks. If you are
installing the switch in an equipment cabinet such as a server cabinet, use the clips and screws that came with the
cabinet in place of the screws that are supplied with the switch.
Complete the following step 1 to attach brackets to the switch. Then, plan which four holes you will be using in the
cabinet and install all four clips. Then proceed to step 2 to install the switch in the cabinet.
24-port and 48-port switches
1. Use a #1 Phillips (cross-head) screwdriver and attach the mounting brackets to the switch with the
included 6-mm M4 screws.
For safe reliable installation, only use the screws provided in the accessory kit to attach the mounting
brackets to the switch.
2. Hold the switch with attached brackets up to the rack and move it vertically until rack holes line up
with the bracket holes, then insert and tighten the four number 12-24 screws holding the brackets to
the rack.
12-port switch
1. Attach the long rack mounting brackets to the switch with the included 6-mm M4 screws. You can
orient the brackets to be flush or offset with the switch front panel (as shown in the following
illustrations). Mounting brackets can also be attached at the middle of the switch.
Aruba 6000 & 6100 Switch Series Installation and Getting Started Guide 19