Graphics Window; Basic Setup; Setting The Overtemperature Switch-Off Point T - Lauda ECO GOLD Operation Manual

7.3.4

Graphics window

The ECO GOLD thermostats offer you the possibility of displaying temperature traces graphically.
7.4

Basic setup

In this section the settings required for using the device as prescribed are summarized. For more extensive settings refer
to the appendix.
7.4.1

Setting the overtemperature switch-off point T

Warning!
Hold the key
-
On releasing you are returned to the menu level without any change.
For T the following applies: 5 Kelvin above the required maximum bath temperature, but below the flash point of the
max
heat transfer liquid.
10/2019 i
In the graphics window the following information is displayed depending on
the setting:
T
set
T
int
T
ext
Overheating due to entering an incorrect T
Set T in each case according to the heat transfer liquid

max
used T must be below the flash point.
max
pressed during the complete setting procedure:
-
The entry window appears. The cursor flashes under the T
maximum and minimum adjustable temperature values are displayed.
-
Note: With a longer depression the figures increment faster.
-
-
ECO Gold
set-point temperature (grey)
internal bath temperature (green)
Temperature on the external consumer, external
temperature sensor (blue).
max
and set-point tempera-
max
ture
Burns, scalds, fire
Press the enter key .
Change the value with
Single figures can be selected by pressing
Confirm your choice with the enter key
value. The
max
or .
or .
.
51 / 137