Table of Contents
Advertisement
3. Unplug the
electrical
connector.
4. Turn the bulb to
the left and
remove it.
5 . Put the new bulb in the lens assembly and turn
it to
the right until it is
tight.
6. Plug in the electrical connector.
7. Put the headlamp lens assembly back into the vehicle. Install and
tighten the two screws.
Front ParkingYTurn Signal Lamps with Sealed Beam
Headlamps
2.
1. Remove the two
screws at the
inside edge of the
parkingkurn
signal lamp
assembly.
Remove the lamp assembly by swinging
it out
from the inside edge and
sliding
it
out at the outside edge.
6-48
Advertisement
Table of Contents
