Table of Contents
Advertisement
Remote Cassette Player
-
€?W
AM-FM Stereo Audio
Compact Disc ATC System
. .
EJECT
i
1
If you have an
ETR@
AM-FM Stereo Audio
Compact Disc ATC
System that includes a
remote cassette player,
the cassette player is
located in the center
panel.
,
of the instrument
Your tape player is built to work best with tapes that are 30 to
45
minutes
long on each side. Tapes longer than that are so thin they may not work well
in this player.
To load a cassette tape with the ignition off, first press EJECT. Then, insert
the cassette tape.
Once the tape is playing, use the control knobs for volume, balance, fade,
treble and bass just as you do for the radio. A lighted tape symbol shows
when a cassette tape is in the player. A lighted arrow will also appear and
show the direction of play when a tape is active.
The player automatically senses if the cassette tape is metal or CRO2 and
adjusts for best playback sound. For metal tapes,
00
(Dolby@ Noise
Reduction) will appear in the display.
Any time a cassette tape is inserted, the top side is selected for play first.
PREV ( 1 )
-
Press PREV or
4
SEEK (in the opposite direction that the
lighted tape direction arrow points) to search for the previous selection. A
minimum three-second blank gap is needed for the player to stop at the
beginning of the selection. The tape direction arrow will blink during the
SEEK operation and the audio is in the mute mode.
PROG (on cassette player)
-
Press PROG to go from one side of the tape
to the other.
NEXT (3)
-
Press NEXT or SEEK
(in the direction that the lighted tape
direction arrow points) to search for the next selection. A minimum
three-second blank gap is needed for the player to stop at the beginning of
the selection. NEXT will appear in the display and the audio is in the mute
mode.
3-25
Advertisement
Table of Contents
