Table of Contents
Advertisement
FADE
-
Press lightly on the FADE knob to release it from its stored
position and pull it
out to the
fully extended position. Rotate the knob
clockwise to adjust sound to the front speakers and counterclockwise to
adjust sound to the rear speakers. Push the knob back in to the stored
position when done.
BAL - Press lightly on the BAL knob to release it from its stored position
and pull it out to the fully extended position. Rotate the knob clockwise to
adjust sound to the right speakers and counterclockwise to adjust sound to
the left speakers. Push the knob back in to the stored position when done.
BASS
-
Press lightly
on
the BASS knob to release it from its stored
position and pull it out to the fully extended position. Rotate the knob
clockwise to increase the bass response and counterclockwise to decrease
bass response. Any time the BASS control is rotated, tone is automatically
set back to MAN (manual). Push the knob back in to the stored position
when done.
TREBLE
-
Press lightly on the TREB knob
to
release it from its stored
position and pull it out to the fully extended position. Rotate the knob
clockwise to increase the treble response and counterclockwise to decrease
treble response. Any time the TREB control is rotated, tone is automatically
set back to MAN (manual). Push the knob back in to the stored position
when done.
To Play a Cassette
Your tape player is built to work best with tapes that are 30 to
45
minutes
long on each side. Tapes longer than that are
so
thin they may not work well
in this player.
To load a cassette tape with the ignition off, first press EJECT or RCL.
Then, insert the cassette tape.
Once the tape is playing, use the control knobs for volume, balance, fade,
treble and bass just
as
you do for the radio. A lighted tape symbol shows
when a cassette tape is in the player. A lighted arrow will also appear and
show the direction of play when a tape
is
active.
The player automatically senses if the cassette tape is metal or CR02 and
adjusts for best playback sound. For metal tapes,
00
(Dolby' Noise
Reduction) will appear in the display.
Any time
a
cassette tape is inserted, the top side is selected for play first.
PREV (1) - Press PREV or
4
SEEK (in the direction that the lighted tape
direction arrow points) to search for the previous selection. A minimum
three-second blank gap is needed for the player to stop at the beginning of
the selection. The tape direction arrow will blink during the SEEK
operation.
3-16
Advertisement
Table of Contents
