Table of Contents
Advertisement
RCL (Recall) - Press this button to change between the clock and the radio
station frequency displayed when the radio is on. Also, press this button to
display the time when the ignition is off.
TUNE -
Press lightly
on
the TUNE button to release it from its stored
position. Rotate the knob clockwise to increase frequency and
counterclockwise to decrease radio frequency. When done, press the knob
again to return it to its stored position.
Pushbuttons
-
The six pushbuttons let you return to favorite stations. To
set the pushbuttons for up to 18 favorite stations (6 AM, 6 FM1 and 6 FM2):
1. Tune in the desired station.
2. Press AUTO TONE to select
the best setting for the type of station
chosen.
3. Press and hold one of the pushbuttons
until sound returns
(approximately two seconds). Whenever you press that button, me
preset station will return.
Repeat these steps for each pushbutton.
SEEK - Press SEEK
to cause the receiver to seek the next higher
station.
Press
4
SEEK to cause the receiver to seek the next lower station.
SCAN
-
Press and hold the center of the SEEK button to momentarily hear
each available station. Release the button when SCAN appears in the
display. The receiver will continue to scan and momentarily stop at each
station until you press the center
of the
SEEK button again.
P. SCAN (Preset Scan) - Press this button to scan each preset pushbutton
station. The receiver will continue to scan and momentarily stop at each
station until you press either P. SCAN again or one of the six pushbuttons.
The AUTO SCAN setting for that preset button will
also
return. The
pushbutton number (PI-P6) will appear momentarily just before frequency
is displayed.
AUTO TONE
-
Press this button to select between five preset equalization
settings and tailor the sound to the music or voice being heard. Each time
you press the button, the selection will switch
to one of
the preset settings of
CLASSIC, NEWS, ROCK, POP, or
JAZZ.
The display will show which
mode the receiver is in. To return to the manual mode, press and release
AUTO TONE until MAN (manual) appears in the display. This will return
the tone adjustment to the TREB and BASS controls. Also, any time a
TREB or BASS control is rotated, tone is automatically set back to MAN
(manual).
3-15
Advertisement
Table of Contents
