Arms And Forks Fully Retracted Proximity Switch - Wittke STARLIGHT Maintenance Manual

3.
Make sure that the proximity switch detects the target on all the detection zone shown below.
4. Once the proximity switch and the target are adjusted, lower the arms.
5. Press the green push-button on the control panel to start the packer.
6.
While the packer is in motion, raise the arms.
These should stop at mid-height on their way up.
7.
If it is not the case, readjust the proximity switch and its target.

Arms and Forks Fully Retracted Proximity Switch

The Arms Fully Retracted proximity switch ensures that the Arms Not Stowed switch on the control
panel is red-lighted if the arms are not completely retracted. Both arms and forks must be completely
retracted for the Arms Not Stowed switch to be green-lighted.
Electrical System 55