Packer Fully Extended Proximity Switch
This proximity switch stops the packer when it reaches its fully extended position (pack cycle).
Figure 5-9
Packer Fully Extended proximity switch
Location
The Packer Fully Extended proximity switch is mounted on the front wall of the body, on the street
side.
This procedure must be performed by 2 people.
I
:
MPORTANT
Testing procedure:
1.
Empty all refuse from the body.
2.
Initiate a pack cycle and observe the fully extended position of the packer.
3.
Adjust the Packer Fully Extended proximity switch if:
• The packer stops before or after reaching the fully extended position (see illustration below).
Adjustment procedure:
1.
Move the packer so that the packer blade is at 4 inches in front of the mid-body breaker bar.
Electrical System 49