Module Locations - Wittke STARLIGHT Maintenance Manual

Module Software Version
On the Module Software Version page, you will find the software version currently used by each of
the modules installed on the truck and by the master control module.
Figure 9-14 Software Version page
With the information on this page it is possible for the operator or maintenance personnel to
determine the electrical schematic number pertaining to a specific vehicle. Looking at Figure 9-14
above you will notice the following digit string 8-8-5-1 between, for example, 10 and R1. As all Labrie
electrical schematics begin with ZS00, you simply add those digits to that base number to get the
corresponding electrical schematic number. So, in this case, the electrical schematic number is
ZS008851.
Press "Esc" to return to the preceding page.
Pump Usage
This section contains an optional hour meter that tracks pump usage for maintenance purposes.
Press "Esc" to return to the preceding page.
Time Adjust
This section allows you to set the Time and Date indicator.
Press "Esc" to return to the preceding page.
N : To go back to the Main Page or Main Menu, press "Esc" as needed until the desired page is
OTE
displayed.

Module Locations

The multiplex control system used on all Labrie & Wittke models has a number of control modules
located throughout the unit. At times, it may be necessary to access those modules to perform
maintenance or diagnostic procedures.
On the W ™ S
ITTKE
points on the chassis and body. Please refer to the following pages for the exact locations of some of
the control modules installed on your truck.
Module 10 = 10_8851_R1
Module 11 = 11_8851_R0
Module 30 = 30_8851_R0
Module 50 = 50_8851_R0
Module 60 = 60_8851_R0
TM
D and S L
UPER UTY TAR
TM
, the control modules are located at various
IGHT
Multiplexing 151