Cummins Engine Parameters - Wittke STARLIGHT Maintenance Manual

Table 8 Output
Wire #
149 PTO enable output
158 Neutral signal output
Table 9 Customer modifiable constant (change only if Labrie auto-neutral)
Automatic neutral - Single input w/selector override
Automatic neutral - Dual input
Automatic neutral - Dual input w/ automatic return-to-range
Automatic neutral - Dual input w/ service brake status
Automatic neutral - Maximum output speed for brake-based auto-neutral

Cummins Engine Parameters

The following table contains the engine programming parameters specific to W
those parameters into Cummins engine ECUs. For more information, call LabriePlus.
Table 10 Cummins engine parameters
Menu: Features &
Parameters
Adjustable low idle
speed
Switched maximum
engine operating speed
N : The values contained in the table above are given as an indication and may vary according to
OTE
truck specifications. If in doubt, call LabriePlus Support Service.
Description
Active when the PTO switch is ON and when all engine
and vehicle speed criteria are respected (+12­V signal).
See Programmed Parameters on page 157.
Active when the transmission is in neutral. This signal
(ground signal) is used to allow fast idle engagement. For
more details, refer to the electrical schematic provided
with the vehicle.
Description
Parameter Name
Low idle speed adjustment switch
---------------------------------------------------------------
Low idle speed
Switched maximum engine operating speed
---------------------------------------------------------------
Maximum operating speed switch setup
---------------------------------------------------------------
Maximum switched engine speed
Multiplexing 159
State
Value
GPI CD if defined
GPI AG if defined
Disabled
GPI AK if defined
500 (RPM)
™ units. Enter
ITTKE
Value
Disable
--------------------
700 RPM
Enable
--------------------
Active closed
--------------------
900 RPM