Adjusting Work Stop; Adjusting Blade Speed - Grizzly G0926 Owner's Manual

Adjusting Work Stop

The Model G0926 is equipped with a work stop
for repetitive cutting operations. The work stop
will need to be adjusted any time it is removed
or repositioned, or anytime you change cutting
length.
Tool Needed
Pencil ................................................................. 1
To adjust work stop:
1. DISCONNECT MACHINE FROM POWER!
2. Measure and mark workpiece for cut.
3. Clamp workpiece in vise and adjust to desired
angle, aligning cutting line with cut mark.
4. Loosen wing nut shown in Figure 30 and
adjust work stop until it contacts workpiece.
Tighten wing nut to secure work stop setting.
Figure 30. Work stop wing nut location.
Model G0926 (Mfd. Since 11/20)
Blade Speed
The Model G0926 is capable of blade speeds
between 85 and 195 FPM (Feet Per Minute). To
adjust the speed, rotate the blade speed dial left
or right until the speed display shows the speed
desired (see Figure 31).
Qty
(Refer to Blade Speed Chart on Page 30 for
blade speed guidelines for various metals.
Blade
Variable-Speed
Dial
Figure 31. Adjusting blade speed.
Adjusting
Blade Speed
Display
-29-