Using Vise - Grizzly G0926 Owner's Manual

Using Vise

The vise consists of a movable jaw and fixed jaw
and can hold material up to 6 inches wide and be
set to cut angles from 0° to 45°.
Always turn saw OFF and allow blade to
come to complete stop before using vise!
Failure to follow this caution may lead to
injury.
Tools Needed
Wrenches or Sockets 13mm ............................. 2
Wrench or Socket 17mm ................................... 1
Machinist's Square ............................................ 1
To use vise:
1.
DISCONNECT MACHINE FROM POWER!
2. Loosen two hex bolts shown in Figure 27.
Hex Bolts
Figure 27. Setting vise angle.
-28-
3.
Use scale as guide or use machinist's square
to set angle of vise, as shown in Figure 28.
Qty
Figure 28. Squaring vise to blade.
4.
Tighten hex bolts.
5.
Loosen hex bolt on movable vise jaw so it
can float, then match angle of workpiece and
tighten hex bolt.
6.
Tighten movable vise jaw against workpiece
using vise crank.
Note: Figure 29 shows correct methods of
holding different workpiece shapes.
RECOMMENDED
Figure 29. Example of workpiece holding options
Scale
NOT
RECOMMENDED
by material shape.
Model G0926 (Mfd. Since 11/20)