Table of Contents
Advertisement
4.
Place square on table bed and against edge
of blade (see Figure 57), and check different
points along length of table between blade
guides.
5.
Loosen hex bolt shown in Figure 57,
and rotate blade guide seat until blade is
perpendicular to bed, then tighten hex bolt.
Square
Figure 57. Squaring blade.
6.
If adjustment from Step 5 does not fully
square blade to table, blade guide bearings
can also be adjusted (refer to Adjusting
Blade Guide Bearings).
Model G0926 (Mfd. Since 11/20)
The blade guide bearings must be properly
adjusted to make square cuts. One bearing on
each assembly has an eccentric bushing that
allows it to be adjusted so the blade is square to
the vise. The bearings are secured in place by a
Hex Bolt
hex nut and lock washer, as shown in Figure 58.
Before adjusting the blade guide bearings, make
sure that you have squared the blade to the table
as discussed in the previous section.
Figure 58. Blade guide adjustment components.
Tools Needed
Machinist's Square ............................................ 1
Wrench or Socket 14mm ................................... 1
Open-Ended Wrench 13mm .............................. 1
Phillips Head Screwdriver #2 ............................ 1
To adjust blade guide bearings:
1.
2.
Adjusting Blade
Guide Bearings
Eccentric Bushing
DISCONNECT MACHINE FROM POWER!
Adjust vise to 90°, then lock in place.
Hex Nut
Qty
-43-
Advertisement
Table of Contents
