Adjusting Positive Stop - Grizzly G0513 Series Owner's Manual

G0513A40 Fence
Cap Screws
Figure 59. G0513A40 fence cap screws.
5.
Adjust the fence face parallel with the edge of
the miter slot.
6.
Tighten the four cap screws, being careful not
to move the fence.
Model G0513X2BF
1. DISCONNECT MACHINE FROM POWER!
2. Make sure the table is aligned with the blade
(see Aligning Table on Page 38 for detailed
instructions).
3.
Install the fence and lock it in place next to
the miter slot.
4.
Loosen the end knobs and the center cap
screw that secure the front rail to the table
(see Figure 60).
Loosen These
Figure 60. Loosen these knobs and cap screw.
-40-
5. Adjust the fence face parallel with the edge of
the miter slot, as shown in Figure 61.
Figure 61. Example of fence parallel with miter
slot.
6.
Tighten the knobs and cap screw that secure
the rail to the table, being careful not to move
the fence.
Adjusting Positive
Stop
The positive stop allows the table to be quickly
and accurately returned to the horizontal (0˚) posi-
tion after being adjusted to a different angle.
Tools Needed
Machinist's Square ............................................ 1
Open-End Wrench 13mm .................................. 1
To adjust the positive stop:
1. DISCONNECT MACHINE FROM POWER!
2. Adjust the blade tension until the mark on the
blade tension scale is between 4 and 6.
3. Loosen the hex nut that locks the positive
stop bolt in place.
G0513 Series Bandsaws (Mfd. Since 08/22)
Qty