Adjusting Zero-Stop Set Screw; Replacing Motor Brushes - Grizzly T33300 Owner's Manual

Adjusting Zero-Stop
Set Screw
The zero-stop set screw (see Figure 28) keeps
the saw resting at exactly 90°.
Figure 28. Location of zero-stop set screw.
Tools Needed
Hex Wrench 2.5mm ........................................... 1
Carpenter's Square ........................................... 1
To adjust zero-stop set screw:
1. DISCONNECT TOOL FROM POWER!
2. Place saw on flat, level surface.
3. Align outside edge of saw with carpenter's
square or straight, level block.
4. Adjust zero-stop set screw until outside edge
of saw is flush against carpenter's square or
block.
-28-
This saw uses two carbon brushes to transmit
electrical current inside the motor. Replace both
carbon brushes at the same time when the motor
no longer reaches full power, or when the carbon
brushes measure less than
are
Tools Needed
Phillips Head Screwdriver #2 ............................ 1
Flat Head Screwdriver
Needle Nose Pliers ............................................ 1
Replacement Brushes (#PT33300024) ............. 2
Zero-Stop
To replace motor brushes:
Set Screw
1.
2.
Qty
3.
Replacing Motor
Brushes
⁄ " long).
5
8
⁄ " ................................. 1
1
8
DISCONNECT TOOL FROM POWER!
Place saw on its side, with motor cover facing
up.
Loosen and remove (4) motor cover screws
(see Figure 29).
x 4
Figure 29. Location of motor cover screws.
Model T33300 (Mfd. Since 04/22)
⁄ " long (new brushes
1
4
Qty