Table of Contents
Advertisement
p18 Mygo Seat - Size 3 Stander User Manual
9.14 ATTACHING THE
HIP LATERALS
Hip laterals are used with the Pelvic
Cradle. First, remove the Pelvic
Harness brackets if required, by
removing the screw and flange nut
. Lift the piece of polypropylene on
the front of the sacral support. Place
the hip lateral brackets into the slots
and attach using the flange nuts
and screws
provided. The flange
nuts should go on the front side of
the sacral support.
B
A
9.15 RETROFITTING THE
DYNAMIC BACKREST
To replace the standard static
backrest with the dynamic backrest
first of all you will need to remove the
screw
at the top of the standard
backrest assembly. To do this loosen
the nut
using the Leckey tool and a
10mm spanner and remove the screw
and washers
Again using the Leckey tool and the
10mm spanner, loosen the nut
the bottom of the standard backrest
assembly then remove screw
saddle washers
washers
.
.
and standard
at
E
Advertisement
Table of Contents
