Table of Contents
Advertisement
Always make sure the
backrest is attached
securely.
Use caution when
inserting inner tube as
there could be possible
finger nip.
9.2 ATTACHING THE
FOOTREST
(if ordered)
If using the Leckey footrests, remove
the seat from the chassis and set
the seating system upside down on
a work surface. Open up the angle of
the leg supports by releasing the two
locking levers
the maximum width. Open the socket
caps
and slide in the calf supports.
Set to the desired position, with
the footplates facing forward and
retighten the socket cap bolts with
the multi-tool.
, shown, and set to
Mygo Seat - Size 3 Stander User Manual p11
Always make sure the foot
plate is attached firmly.
9.3 ATTACHING THE
SEAT TO THE HI-LOW
CHASSIS
Adjust the height of the chassis to
its maximum to reduce risk of back
strain while attaching the seat unit.
Refer to Section 12 on how to adjust
the height of the chassis you have
purchased.
Advertisement
Table of Contents
