Configuring The Brake System - PRONAR T700 Operator's Manual

Pronar T700
while adjusting the lifting jack, transfer the lug (5) to the correct height (there
are 3 possible settings) and secure with bolts (6).
You can also adjust drawbar position by transferring the rocker arm pin (7) to the
corresponding hole of the spring (4) rocker arm to obtain different height settings. It is
possible to transfer the pin in one of the three holes of the rocker arm.

5.12 CONFIGURING THE BRAKE SYSTEM

In preparation for the hitching of the trailer for the first time, check the type of the tractor
system and possibly configure the trailer brake system. The standard trailer is equipped with
a double conduit system. If the tractor is equipped with a single conduit brake system, the
trailer's system must be configured for the tractor. In order to do this:
remove the yellow spiral conduit (1) together with the connector,
in place of the removed conduit plug the filter (3) with the cap (4) and washers
(5) that are supplied with the trailer,
Replace the red connector mounted on the red spiral conduit (2) with the
black connector (6) (no. 87.30.010.0), which is supplied with the trailer.
If the system is equipped with the rear output connectors, replace the
rear red connector and replace it with the black connector
No 87.40.011.0.
5.40
SECTION 5