–
Remove cotter pin
–
Press back the brake linings by slightly tilting the brake caliper later-
ally on the brake disc.
–
4
Remove pin
–
Remove brake linings
–
Clean brake caliper.
–
Position the retainer spring.
–
Position the new brake linings.
S04288-10
Info
Always change the brake linings in pairs.
–
4
Mount pin
.
Info
To make it easier to mount the pin, push the brake linings
upwards against the retainer spring.
Make sure the brake linings and retainer spring are seated
correctly.
–
Mount cotter pins
–
Check the brake discs. (
–
Operate the foot brake lever repeatedly until the brake linings are in
contact with the brake disc and there is a pressure point.
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the cover with the washer and membrane
–
Mount and tighten screws
Info
Use water to immediately clean up any brake fluid that has
overflowed or spilled.
A00056-10
3
.
.
5
and the retainer spring.
3
.
p. 69)
A
.
p. 117)
1
.
BRAKE SYSTEM 12
2
.
79