Lcd Description - Eaton 5PX Advanced User's Manual

4.2 LCD description

As default, or after 5 minutes of inactivity, the LCD displays the screen saver.
The backlight LCD automatically dims after 5 minutes of inactivity. Press any button to restore the screen.
Note. If other indicator appears, see troubleshooting page for additional information.
The following table describes the status information provided by the UPS :
Operation status Possible cause
Standby mode
The UPS is OFF, waiting for start-up
command from user
Normal mode
The UPS is operating normally.
In AVR mode
The UPS is operating normally but the
utility voltage is outside Normal mode
thresholds.
No beep
On Battery
A utility failure has occurred and the
UPS is in Battery mode.
One beep every 10
seconds
End of backup time
The UPS is in Battery mode and the
battery is running low.
1 beep every 3
seconds
614-40094-00
① Load status and measurements
② Equipment status icon
③ Status / Message
④ Battery status
Action
Equipment is not power until button
during start up and the green "normal mode" LED
indicator is illuminated.
The UPS is powering and protecting the equipment.
The UPS is powering the equipment through the
Automatic Voltage Regulation device. The equipment is
still normally protected.
The UPS is powering the equipment with battery
power. Prepare your equipment for shutdown.
This warning is approximate, and the actual time to
shutdown may vary significantly. Depending on the
UPS Load, the "Battery Low" warning may occur before
the battery reaches 20% capacity remaining.
is pressed
17