Start-Up; General Rules For Making Adjustments To The Spray Gun; Preparation - WAGNER GM 2800EA Operating Manual

EDITION 10/2005
OPERATING MANUAL
5.3

START-UP

5.3.1

GENERAL RULES FOR MAKING ADJUSTMENTS TO THE SPRAY GUN

➞ See safety regulations in chapter 2.
5.3.2

PREPARATION

•
Secure the spraygun. Turn tension cap clockwise until stop. (viewed from back of gun)
•
Connect material hose to pump.
•
Connect air hose to oilfree, dry air supply approx. 0.25 MPa; 2.5 bar; 36 psi with regulator.
•
Connect electric cable of the spray gun to the control unit.
•
Visually check the permissible pressures for all the unit components.
•
Make sure that the spraying unit and all other conductive parts within the work area are
earthed.
•
Set material pressure and use a suitable medium (solvent or water) to check that connec-
tions do not leak.
•
Relieve unit pressure and secure the spraygun.
PART NO. DOC0388891
GM 2800EA
26