Replacing The Paint Hose - WAGNER GM 2800EA Operating Manual

EDITION 10/2005
OPERATING MANUAL
8.5

REPLACING THE PAINT HOSE

1. Unscrew nut (A) using the universal spanner.
2. Pull material hose (B) out of the connection (C).
3. Remove insert (D), clamping ring (E) and nut (A) from material hose.
4. Pull the material hose back through the protective sleeve (F) and remove it.
If the material hose has been ordered per meter, strip the insulation from 75 mm; 3.0 in
at both ends. Pay attention not to damage the hose
5. Push the new material hose (without union nut and clamping ring) through the
protective sleeve (F).
6. Fit the nut (A) and clamping ring (E) over the material hose (B).
7. Insert the cleaned or new sealing sleeve (D) into the material hose (B).
8. Wet the material hose (B) on the insert length with insulating oil (castor oil).
Note
The high-voltage oil protects against high-voltage burn through. (leakage to earth or
atmosphere)
9. Insert material hose (B) into the connection (C) as far as it will go.
10. Pull the union nut (A) over the clamping ring (E) and gently tighten it with the universal
spanner.
Mounting with insulating oil
PART NO. DOC0388891
GM 2800EA
38