Epilog Laser Mini Manual page 10

Step 12
Connect the motor wires (red and black twisted wire with a black quick disconnect at the end) by
plugging the black quick disconnect in to the circuit board just to the rear of the motor.
Step 13
Connect the Fan wires by plugging the black quick disconnect in to the circuit board just to the
rear of the motor.
Step 14
On the left side of the I-beam locate the Pulley which the belt wraps around. (See
Step 4.) Loosen the Philips screw holding the pulley in place. The spring will pull the belt tight. Retighten
both Philips screws to keep the belt tight as the engraver operates.
Fan Assembly Upgrade
Mini / Helix
Revision Date: 2/21/2013
M
Procedure A -
pg. 10 of 11