Epilog Laser MINI 18 Manual

Fan replacements

EPILOG LASER

16371 Table Mountain Parkway

Golden, Colorado 80403

Phone 303-215-9171 - FAX 303-277-9669

www.epiloglaser.com

Procedure:

FAN REPLACEMENTS

Machine Type: MINI 18, 24 and Helix

Tools Needed: #2 Phillips head screwdriver, 6/32 Nut driver

Flat head screwdriver or wire cutter

1. Turn engraver off and unplug it from the wall.

2. Face the back of the machine where the exhaust is located.

3. Remove the 8 screws holding the back panel in place using the #2 Phillips head

screwdriver.

4. The laser tube is silver in color and sits directly above the exhaust outlet. Disconnect

the gray communication cable from the left side of the laser tube by pressing the plastic

tab on it and pulling it free from the laser tube itself.

(PIC #1)

5. Next, disconnect the black and red wire connection located on the left side of the laser

tube by unplugging it from the wiring harness. To do this, simply press down on the

plastic tab of the connector and pull free from the plug of the wiring harness.

(PIC# 3)

(PIC#2)

Table of Contents

Do you have a question about the MINI 18 and is the answer not in the manual?

Page 1 Phone 303-215-9171 - FAX 303-277-9669 www.epiloglaser.com Procedure: FAN REPLACEMENTS Machine Type: MINI 18, 24 and Helix Tools Needed: #2 Phillips head screwdriver, 6/32 Nut driver Flat head screwdriver or wire cutter 1. Turn engraver off and unplug it from the wall.
Page 2 6. You will now need to unplug the Red Dot pointer. This is located on the right side of the laser tube. There is a small red and black wire that comes from the diode and connects to a black connector. Disconnect this connector by pressing on the plastic tab and pulling the connector free.
Page 3 10. To replace the fan there are two black plastics push pin holding it. To take it off you will need to get some wire cutter or flat screwdriver and pop the head out. There will be two replacement push pin when changing out the fan. 11.

Mini 24Helix