Description Of Potentiometer Jp; Buzzer; Description Of Push Button - Renesas RL78/I1D User Manual

DETECT-IT RL78/I1D detector boards kit
Jumper Status
J1 Closed
Open
J2 Closed
Open
J3 Closed
Open
In order to start the demonstration of the Glass Break detector, please ensure that this initial configuration is done:
• J1 should be closed
• J2 should be closed
• J3 should be closed
5.1.3

Description of Potentiometer JP

Table Description of potentiometer of Glass Break detector
Potentiometer Function
JP10 IVREF1
comparator 1
JP11 IVREF0
comparator 0
5.1.4

Buzzer:

The buzzer is used for alarm by the application. It is connected to MCU pin P01/PCLBUZ1
5.1.5

Description of Push Button

The push button is connected MCU pin P137 / INTP0 via R3, and used as "Reset" function. The Interrupt function can
be found in the project file "r_cg_intc_user.c"
Table Description of push button of Glass Break detector
UM-YDETECT-IT-RL78 V1.30
Function
Power supply of the MCU and others components [MCU, Alarm/buzzer,
AVDD via L1, U1 Vin (optional), pull up resistors, R16/R10 and R13/R19]:
power from battery or power from E1 via CN01-pin 5, CN02-pin 4
Caution: Battery should never be installed when using E1 power supply or
external power supply via CN02/CN01
Current measurement of the MCU and others components [MCU,
Alarm/buzzer, L1and AVDD, U2 Vin (optional), pull up resistors] by
connection of the ampere meter
Power supply of some components [R18, R17, R15, R11, J3] on glass break
detectors board
Current measurement of some components [R18, R17, R15, R11, J3] by
connection of the ampere meter
Usage of RL78/I1D comparators
(motion detector and glass break detector board)
Comparators are not used, IVREF0 & IVREF1 are not used
(CO detector and smoke detector board)
Comment
Set JP10 potentiometer for IVREF1 (DNI_J3, pin 1) = 2.0V
Approximately (0.58*VDD) at VDD = 3.4V
(Use a voltmeter with at least 10M input impedance as lower
impedance (such as 1M ) will significantly load down the resistor bias
chain).
Set JP11 potentiometer for IVREF0 (DNI_J2, Pin 12) = 1.2V
Approximately. (0.35*VDD) at VDD = 3.4V
(Use a voltmeter with at least 10M input impedance as lower
impedance (such as 1M ) will significantly load down the resistor bias
chain).
Kit User Manual
Page 21 of 59