DETECT-IT RL78/I1D detector boards kit
5.3.1
Oscillators
Each board is equipped with 2 oscillators:
• A 20 MHz oscillator
The 20 MHz oscillator is sold onto each board and connected to the MCU. But it is not used by the application.
Instead the internal High Speed on-chip oscillator of the RL7/I1D is used by each application. So pin P121/X1
and pin P122/X2 are used as Input.
• Please change the settings if you wish to use the external oscillator.
• A 32,768kHz quartz
It is connected to the MCU
It is operating and used by the application (especially by the RTC).
5.3.2
Description of Jumper J
Table
Description of jumper of Motion detector
UM-YDETECT-IT-RL78 V1.30
Figure Motion detector components bottom view
Kit User Manual
Page 32 of 59