Ethernet Connection; To Connect To The Network; Requirements For Computers And Mobile Devices; User Software And Printer Driver Requirements - Canon imagePRESS Server В5000 Configuration And Setup

Ethernet connection

For Ethernet connections, the imagePRESS Server supports Shielded Twisted Pair (STP) cabling for certain network
speeds.
The following network speeds are supported:
•
10BaseT: Category 3 or later
•
100BaseTX: Category 5 or later (4‑pair/8‑wire, short‑length)
•
1000BaseT: Category 5e or later (4‑pair/8‑wire, short‑length)

To connect to the network

1 Power off the printer and the imagePRESS Server (see
2 Connect the cable from the network to the network port (RJ-45) on the imagePRESS Server (see
on page 20).
Important: If you are concerned about information being extracted from the imagePRESS Server Ethernet
port without authorization, consider securing the Ethernet port.
3 Power on the printer.
Note: The printer must be on before you start the imagePRESS Server.
4 Power on the imagePRESS Server by moving the power switch to the ON position and then pressing the power
button.
For more information about powering on the imagePRESS Server, see
on page 100.
Important: When the imagePRESS Server is in use, do not connect or disconnect the network cable
connected to the printer or disable the network functions.

Requirements for computers and mobile devices

System requirements for client computers and mobile devices are as follows.

User software and printer driver requirements

The following are required to install and use Fiery applications and printer drivers:
Control power to the imagePRESS Server
Control power to the imagePRESS Server
Configuration and Setup
System requirements
on page 100).
Connector panel
23