Io-Link Interface - Siemens SIMATIC ET 200AL System Manual

System overview

2.3 IO-Link interface

2.3 IO-Link interface
Introduction
The IO-Link is a serial, bidirectional point-to-point connection for signal transmission and
power distribution under any network, fieldbus or backplane bus.
Connection system in IP65/67
M12 connectors and other connectors are defined for the connection system in IP65/67;
sensors have a 4-pin connector, actuators a 5-pin connector. IO-Link masters are always
equipped with a 5-pin M12 socket.
The pin assignment according to IEC 60974-5-2 is specified as follows:
● Pin 1: 24 V
● Pin 3: 0 V
● Pin 4: Switching and communication cable (C/Q)
In addition to IO Link communication, these three pins also implement the power supply of
the device.
Detailed information about the power supply can be found in the documentation of the
utilized IO-Link master.
Figure 2-2
12
Pin assignment IO-Link device
Function Manual, 12/2017, A5E31637677-AB
IO-Link system