Internal Peripherals Connectors; Enhanced Ide And Floppy Connectors; Serial Ata Connectors (Sata1/Sata2) - Shuttle FT20 User Manual

Amd athlon 64 processor based ddr main board

Table of Contents

Internal Peripherals Connectors

The mainboard features one 40-pin dual-channel IDE device connectors (IDE1)

providing support for up to two IDE devices, such as CD-ROM and Hard Disk

Drives (H.D.D.). This mainboard also includes one 34-pin floppy disk control-

ler (FDC) to accommodate the Floppy Disk Drive (FDD1). Moreover, this

mainboard comes with one 80-pin ATA 133/100/66/33 ribbon cable to con-

nect to IDE H.D.D. and one 34-pin ribbon cable for F.D.D. connection.

Important : Ribbon cables are directional, therefore, make sure to always

The Serial ATA is an evolutionary re-

placement for the Parallel ATA physi-

cal storage interface. Serial ATA is scal-

able and will allow future enhance-

ments to the computing platform. The

Serial ATA supports all ATA and ATAPI

device, including CDs, DVDs, tape de-

vices, high capacity removable de-

vices, zip drivers, and CDRWs. The

Serial ATA interface supports data trans-

fer rates up to 150MB/s.

IDE1

connect with the red cable stripe on the same side as pin #1 of

the IDE1/IDE2 or FDC connector on the mainboard.

- 32 -

FLP1

SATA1

SATA2

Table of Contents