Table of Contents
Advertisement
F
Internal Peripherals Connectors
Enhanced IDE, Floppy Connectors
D1
The mainboard features two 40-pin dual-channel IDE device connectors
(IDE1/IDE2) providing support for up to four IDE devices, such as CD-ROM
and Hard Disk Drives (H.D.D.).
This mainboard also includes one 34-pin floppy disk controller (FDC) to
accommodate the Floppy Disk Drive (FDD). Moreover, this mainboard
comes with one 80-pin ATA 100/66/33 ribbon cable to connect to IDE
H.D.D. and one 34-pin ribbon cable for F.D.D. connection.
Important:
Ribbon cables are
directional, there-
fore, make sure to
always connect
with the red cable
stripe on the same
side as pin #1 of
the IDE1/IDE2 or
FDC connector on
the mainboard.
Serial ATA Connectors
D2
The Serial ATA is an enolutionary replacement for the Parallel ATA physical
storge interface. Serial ATA is scalable and will allow future enhancements to
the computing platform. The Serial ATA supports all ATA and ATAPI device,
including CDs, DVDs, tapes devices, high capacity removeable devices, zip
drivers, and CDRW's.
The Serial ATA interface supports data transfer
rates up to 150MB/s.
IDE1
1
- 34 -
1
1
IDE2
Advertisement
Table of Contents
