Jumper Settings - Shuttle FT20 User Manual

3.2 Jumper Settings

Several hardware settings are made through the use of mini jumpers to connect
jumper pins on the mainboard. Pin #1 could be located at any corner of each
jumper, you just find the location with a white right angle which stands for pin
1#. There are several types of pin 1# shown as below:
3-pin and multi (>3) pin jumpers shown as following:
Pin #1 to the left:
Pin #1 on the top:
Pin #1 to the right:
Pin #1 on the bottom:
Jumpers with two pins are shown as
Open [Off]. To Short jumper pins, simply place a plastic mini jumpers over
the desired pair of pins.
Caution!
1. Do not remove the mainboard from its antistatic protective packaging
until you are ready to install it.
2. Carefully hold the mainboard by its edges and avoid touching its comp-
onents. When putting the mainboard down, place it on top of its origi-
nal packaging film, on an even surface, and components side up.
3. Wear an antistatic wrist strap or take other suitable measures to prevent
electrostatic discharge (ESD) whenever handling this equipment.
for Close [On] or
- 23 -
for