IKEA FIXA Manual page 8

Note: The battery that is supplied with the
screwdriver has been charged for test purposes
only and must be fully charged before first time
use.
First read the safety instructions and then follow
the loading instructions. Insert the charger plug
into the socket in the screwdriver/drill. Then
connect the charger to the electricity supply.
Make sure that there are no knots or sharp bends
in the cable.
The charger's transformer and the battery have
been designed to be used together.
NEVER use this charger to recharge cordless tools
or batteries from other manufacturers.
The battery will gradually lose its charge over a
period of time, even if the tool is not used.
The lithium-ion battery is protected against deep
discharging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the machine is
switched off by means of a protective circuit: The
tool no longer rotates.
WARNING! Do not continue to press
the forward/reverse switch after the machine
has been automatically switched off. The
battery can be damaged.
WARNING! Recharge the battery on a
non-flammable surface. Do not recharge the
battery for more than eight hours. The red
diode will go out when the battery has been fully
loaded.
Disconnect the cable and store the charger in a
suitable place when it is not in use.
It is not advisable to recharge the battery in
temperatures below freezing.
INSTRUCTIONS FOR USE
Note: Sparks may be visible through the slots in
the motor housing during operation. The sparks
are a normal reaction of the motor when in use
and are created by the components inside the
motor moving against each other. The function
of the power tool is not affected by this. We do
however recommend not to use the power tool
near any flammable liquids, gases or dust, which
the sparks may ignite.
Regulating the shaft speed
It is possible to regulate shaft speeds from zero
to maximum by altering the pressure applied to
the trigger.
Reversing the direction of rotation
You can reverse the direction of rotation by using
the selector above the trigger.
To lock the trigger, set the selector to the mid
position between the right and left options.
Adjusting the tightening moment
Turn the torque regulator to the desired position.
Settings 1-15 are used for tightening/loosening
screws (the higher the value, the greater the
tightening moment). Select the drill symbol
before using the tool for drilling.
Keyless chuck
Your drill has a keyless chuck so that you can
simply tighten or release drill/driver bits.
To open/close the chuck hold the rear ring and
rotate the front sleeve.
WARNING: RISK OF TRAPPING
Do not hold the front sleeve of the chuck with one
hand at the same time as you open or close the
jaws of the chuck with the help of the drill/driver´s
motor.
Mounting drill/driver bits
Set the drill/driver´s trigger in mid position.
Adjust the chuck until the opening is slightly
larger than the shaft of the drill bit that you wish
to use.
Insert the drill bit into the chuck.
Tighten the chuck against the drill as described
above (Keyless chuck).
8