General Procedure - Siemens SIMATIC NET RUGGEDCOM RST2228P Installation Manual

Installing the Device
2.1 General Procedure
This product should be installed in a restricted access location where access can only
be gained by authorized personnel who have been informed of the restrictions and
any precautions that must be taken. Access must only be possible through the use
of a tool, lock and key, or other means of security, and controlled by the authority
responsible for the location.
2.1

General Procedure

The general procedure for installing the device is as follows:
The user is responsible for the operating environment of the device, including
maintaining the integrity of all protective conductor connections and checking
equipment ratings. Make sure to review all operating and installation instructions
before commissioning or performing maintenance on the device.
1.
2.
3.
4.
5.
6.
7.
8.
10
NOTICE
NOTICE
Review the relevant certification information for any regulatory
requirements.
For more information, refer to
Review the Modules Catalog for the device for special installation or
regulatory requirements related to the modules installed in the device.
For more information, refer to
Unpack and inspect the device.
For more information, refer to
Mount the device.
For more information, refer to
Connect the failsafe alarm relay.
For more information, refer to
14)".
Connect power to the device and ground the device to safety Earth.
For more information, refer to
Connect the device to the network.
For more information, refer to
Configure the device.
For more information, refer to
"Approvals (Page 43)".
"Related Documents (Page
"Unpacking the Device (Page
"Mounting the Device (Page
"Connecting the Failsafe Alarm Relay (Page
"Connecting Power (Page
"Communication Ports (Page
"Configuring the Device (Page
Installation Manual, 07/2021, C79000-G8976-1403-13
v)".
11)".
11)".
15)".
33)".
28)".
RUGGEDCOM RST2228P