Maintenance; Engine, General - Volvo Penta D3-130A Operator's Manual

Maintenance

This chapter describes how to carry out the maintenance. Read the instructions carefully before starting work.
Maintenance intervals are contained in the chapter "Maintenance schedule".
WARNING! Read the safety precautions for maintenance and service in the chapter "Safety Information",
before starting work.
WARNING! Unless otherwise specified all maintenance and service must be carried out with the engine
stopped. Stop the engine before opening or removing engine hatches. Immobilize the engine by removing
the ignition key, turning off the power supply with the main switch.

Engine, general

General inspection
Make a habit of "visually" inspecting the engine and en-
gine room before starting the engine and after stopping
when the engine has been turned off. This will help you
to quickly detect abnormalities that have occurred or
are about to occur.
Look especially carefully for oil, fuel and coolant leaks,
loose bolts, worn or slack drive belts, loose connec-
tions, damaged hoses and electric cables. This inspec-
tion takes only a few minutes but can prevent serious
operating disturbances and costly repairs.
WARNING! Accumulations of fuel, oil and grease on
the engine or in the engine room is a fire hazard and
must be removed immediately they are detected.
IMPORTANT! If an oil, fuel or coolant leak is de-
tected, the cause must be investigated and the
fault rectified before the engine is started.
IMPORTANT! Never point high-pressure water
jets directly at seals, rubber hoses or electrical
components. Never use the high-pressure function
when washing the engine.
49