Volvo Penta D3-130A Operator's Manual page 50

Maintenance schedule
cont. Every 200 hours / at least once a year, included in Extended Protection Service:
● XDP drive. Oil change ............................................................................... page 76-77
● SX and DP-S drives . Grease CV joint and primary shaft bearing ............. page 73-74
● SX and DP-S drives. Checking CV joint and exhaust bellows. .......................page 73
● Reverse gear. Change oil and filter .................................................................page 67
● Engine oil. Change
● Oil filter. Change
● Air filter. Change ............................................................................................page 50
● Exhaust line. Checking .................................................................................. page 50
● Sea water pump. Checking of impeller ...........................................................page 58
● Fuel filter/ fuel pre-filter. Change ............................................................... page 60-61
Clean and touch up the paintwork as necessary ........................................ not shown
Check the condition of all rubber hoses, and re-tighten the hose clamps ... not shown
Every second year:
SX, DP-S and XDP drive. Change exhaust and universal joint bellows ...... not shown
● Coolant. Change ............................................................................................page 56
Every 600 hours / at least every 5 years:
Reverse gear. Changing the propeller seal ................................................. not shown
Turbo. Inspection/cleaning as necessary ................................................... not shown
Trim/steering cylinders, hoses, hydraulic hoses. Leakage check ............... not shown
Outboard drive, check for function and wear .............................................. not shown
– Bushes/shaft stubs in shield and suspension fork
– Propeller shaft seal
– Propeller shaft, checking straightness
– Gear change mechanism and control cable
– Steering
Every 1200 hours / at least every 5 years:
Heat exchanger. Inspection/Cleaning ......................................................... not shown
Intercooler. Inspection/Cleaning ................................................................. not shown
Control cables and seals. Change .............................................................. not shown
Coolant pipes. Inspection ........................................................................... not shown
– Checking hoses, unions and hose clamps
Safety and function check ........................................................................ not shown
– In a safety and function check, the outboard drive is disassembled to check for wear
and damage. Any faults are rectified. If necessary, the complete drive is changed.
Every 1400 hours:
Camshaft belt. Change .............................................................................. not shown
1) Oil change intervals vary, depending on oil grade and sulfur content of the fuel. Please refer to
"Maintenance: Lubrication system".
2) Change the filter at each oil change.
48
1) ......................................................................................page 53
2) .........................................................................................page 52