Carel µAM User Manual page 62

En02 Type of system:
0 = 2 pipes;
1 = 4 pipes (chiller only, not heat pump).
Note:
Based on the settings of Ch01, En01, En02, En03, some operating modes for the µAM, e-drofan and µC
see the "Summary table of operating modes"
En03 Boiler available controlled by µChiller
0 = not available;
1 = available.
Note 1:
Based on the settings of Ch01, En01, En02, En03, some operating modes for the µAM, e-drofan and µC
see the "Summary table of operating modes"
Note 2:
When En03=1, the value one of the parameters P25 to P32 on the µC
control with a physical ON/OFF output. The parameters will only be used when H11=12.
En04 Use clock and time bands:
1 = enabled;
0 = disabled.
En05 Lock the acqua and e-droset terminal keypad connected to the master e-drofan:
0 = Buttons unlocked;
1 - 9 = Selective locking of combinations of buttons. See the following table.
Pc01 Calibration of the built-in temperature probe on the µAM
Fr01 Display the firmware version of the µAM
(1) Visible only if the features the humidity probe
µAM
Buttons locked on the terminal
ON/OFF
MODE
FAN
SET
CLEAR/SLEEP
TIMER
UP
DOWN
2 SE with ON / OFF control
2 SE must be set for the "boiler" function to associate the
0
30
SE may not be available;
2
2 SE may not be available;
Parameter En05: Lock the acqua and e-droset terminal keypadt
1 2 3 4
0 0 1
0 0 1
1 0 1
0 0 9
0.0 -9.9 9.9 °C
En05
5 6 7 8
µAM +030220460 rel. 1.0 - 08.05.2007
Tab. 6.a
9
Tab. 6.b