Table of Contents
Advertisement
No.
Info. message
203
Fill level aquaCool
canister low
204
Connection aquaCool
unit faulty
205
Connection audio
module faulty
206
Connection inside
display faulty
207
aquaCool canister empty
208
Aroma supply low,
please renew
209
aircon:condensed-water
canister full, please empty
210
Low battery charge,
please renew
211
Connection preselect
display faulty
212
Connection RGB-
module faulty
213
SD card missing
214
SD card unreadable
215
Connection to easy
Care terminal faulty
216
Voltage varies, blease check
217
No voice files on the SD
card, pleas check.
226
Quicktest Sensortoleranz
OK
227
Quicktest Sensortolerance
error
INFORMATION MESSAGES
Description
The content of the aquaCool canister is
sufficient for another 2.5 hours of operation
with a spraying time of 6 seconds each.
Communication between control and
module / display has been interrupted.
aquaCool canister empty.
System has run out of scent.
Condensate canister of air-conditioning
unit full.
Button cell (CR-2032) of the control board
discharged.
Communication
between
and "preSelection" display has been
interrupted.
No SD card in the audio module.
SD card defective, incompatible content.
Communication between control and ea-
syCare terminal has been interrupted.
Power supply to the mainboard varies
No voice files on the SD card found.
Sensor Quicktest log entry - No display
appears - Message will be stored directly
in the event log (service menu).
Remedy
Replace the empty aquaCool canister with a full one.
Do not replace aquaCool with any other liquid.
Check / replace the patch cable. Acknowledge the
message by pressing START. If the fault persists,
contact your Customer Service.
Replace the aquaCool canister with a full one.
See chapter: Refilling Aroma and aquacool
Replace the Aroma tin.
See chapter: Refilling Aroma and aquacool
Empty the condensate canister of the air-conditioning
unit, acknowledge the message by pressing START.
Replace the button cell (CR-2032).
control
Check / replace the patch cable. Acknowledge the
message by pressing START. If the fault persists,
contact your Customer Service.
Insert an original SD card.
See chapter: Recording to an SD card/Removing the
SD card
Insert a new original SD card. Acknowledge the
message by pressing START. See chapter: Recording
to an SD card/Removing the SD card. If the fault
persists, contact your Customer Service.
Check cable connections and power supply. Ack-
nowledge the message by pressing START. If the fault
persists, contact your Customer Service.
Check power supply to the mainboard.
Rebuild voice folder on the SD card. If necessary re-
place original SD card.
M a n u a l e o p e r a t i v o | megaSun 6700 - 6800 - 6900
55
Advertisement
Table of Contents
