Configuration And Operation; Start-Up; Main Menu; View Transmitter Status - Bosch INTEGRUS Installation And Operating Manual

INTEGRUS | Installation and Operating Manual | Infra-Red Transmitters
2.5 Configuration and
operation
The next sections give descriptions of the possible con-
figuration options. Each description is followed by the
relevant menu items with detailed information per
menu option. The default values (see section 'Reset all
options to factory defaults') are indicated by an asterix
(*) when applicable.
2.5.1

Start-up

When the transmitter is switched on, the display shows
the Transmitter Status screen, which is the first item of
the Main menu. The display also goes to this screen
after 5 minutes of inactivity.
In case the system detects a fault, the display shows a
flashing fault message (see section 2.5.4).

2.5.2 Main menu

The main menu contains the screens to view the trans-
mitter status and the radiator fault status. It also con-
tains the entry points to the Monitoring, Enquiry and
Setup sub-menus.
Menu Item
Transmitter Status
1 Fault Status
2 Monitoring . . .
3 Enquiry . . .
4 Setup . . .

2.5.3 View transmitter status

The first screen of the Main menu gives information
about the present status of the transmitter. The screens
shows the name of the transmitter (1st line) and the
present transmission mode (2nd line). See examples
below. See section 2.5.7 to change the transmission
mode.
Transmitter
10 Channels DCN
Transmitter is transmitting
10 channels from DCN.
Bosch Security Systems | 2003-02 | 3122 475 22011en
Description
Shows the transmitter status
(see section 2.5.3)
Shows the radiator fault status
(see section 2.5.4)
Go to the 'Monitoring' sub-menu
(see section 2.5.5)
Go to the 'Enquiry' sub-menu
(see section 2.5.6)
Go to the 'Setup' sub-menu
(see sections 2.5.7 and higher)
Transmitter
Aux to All
Transmitter is transmitting the
Aux inputs on all channels.
Transmitter
Standby
Transmitter is in Standby mode
(not transmitting).
en | 25