Set Monitoring Options; View Version Information - Bosch INTEGRUS Installation And Operating Manual

INTEGRUS | Installation and Operating Manual | Infra-Red Transmitters

2.5.5 Set monitoring options

The Monitoring sub-menu (2) is used to set which sig-
nal is sent to the monitoring headphone output. It can
be one of the inputs, one of the channels or no signal.
When the sensitivity of one of the inputs is being
changed in the Setup menu (4I, 4J or 4K), or when
assigning inputs to channels (menu 4C, Per Channel),
the monitoring output automatically switches temporar-
ily to that source, even when the option 'None' has
been chosen.
When the headphone output is disabled (see section
2.5.17), the output level can not be changed and the
level indicator is not visible.
Menu Item
2A Source/Volume
The 'Source/volume' screen also displays level meters (two
for a stereo source, one for a mono source) for a visual indi-
cation of the actual signal strength: I = low level,
level, L = overflow.

2.5.6 View version information

In the Enquiry sub-menu (3), version information of
the transmitter can be found. This information should
be mentioned in service requests or failure reports.
Menu Item
3A Board Nr
3B Board Version
3C Software Version
Bosch Security Systems | 2003-02 | 3122 475 22011en
Option Value 1
Source;
- In. nn Input nr:
00 ... 31
- Ch. nn Channel nr:
00 ...31
- Aux.L
- Aux.R
- None
I
= high
Value (read only)
e.g. 19.1.000001
e.g. 01.00
e.g. 1.00.0001
Value 2 Description
Volume: The signal from audio input nn is available
-31 ... 0 dB on the monitoring headphone output.
Volume: The signal on channel nn is available on the
-31 ... 0 dB monitoring headphone output.
Volume: The signal on the Aux. Left input is available on
-31 ... 0 dB the monitoring headphone output.
Volume: The signal on the Aux. Right input is available
-31 ... 0 dB on the monitoring headphone output.
Volume: The monitoring headphone output is switched off
-31 ... 0 dB during normal operation, but is active when the
sensitivity of one of the inputs is being changed.
Description
Shows the serial number of the transmitter board.
Shows the version number of the transmitter board.
Shows the version number of the configuration software.
en | 27