View Fault Status - Bosch INTEGRUS Installation And Operating Manual

INTEGRUS | Installation and Operating Manual | Infra-Red Transmitters
Menu Items
Transmitter Status

2.5.4 View fault status

The fault status of the radiators can be seen in the sec-
ond screen of the Main menu:
Menu Items
1 Fault Status
When the system detects a failure for the first time, a
flashing fault message pops-up on any menu screen:
Radiator Fault
Push the menu button to remove the fault message
from the screen and to go back to the menu screen
that was visible before the fault message popped-up.
The flashing message will also disappear when the fault
has been resolved.
Bosch Security Systems | 2003-02 | 3122 475 22011en
Options (read only)
Name
Mode:
- nn Channels
- Aux to All
- nn Ch. Test
- Slave
- Standby
- Emergency Call
DCN
Value (read only)
Fault:
- No Faults
- Radiator Fault
- No Radiators
No Radiators
or
Description
The first line shows the user defined name of the transmitter (see
section 2.5.15).
The second line shows the actual transmission mode:
Audio signals are distributed on nn channels.
The signal on the Aux. inputs is distributed on all channels.
The test signals are distributed on nn channels.
The transmitter operates in slave-mode: the radiator signal on the
slave input is looped-through to all radiator outputs.
The transmitter is in stand by mode.
An emergency signal from the Aux. inputs is distributed to all chan-
nels.
The text 'DCN' is shown at the right side of the second line when a
DCN system is connected to the transmitter.
Description
The connected radiators function without problems.
One of the connected radiators is not functioning properly.
No radiators are connected to the transmitter.
en | 26