Set Transmission Mode; Set Number Of Channels - Bosch INTEGRUS Installation And Operating Manual

INTEGRUS | Installation and Operating Manual | Infra-Red Transmitters

2.5.7 Set transmission mode

The Transmission Mode menu item (4A) is used to
select which signals will be distributed over the chan-
nels. It is also possible to switch all channels off
(Standby).
When using a DCN interface module of version 01.05
or higher, the transmitter is automatically switched to
'Standby' when the connected DCN system is
switched off. When the DCN system is switched on,
the transmitter is automatically switched to 'On'.
Menu Item
4A Transmission

2.5.8 Set number of channels

Via sub-menu item 4B the number of channels that
will be used can be set. Note that the maximum num-
ber of channels depends on the transmitter type (4, 8,
16 or 32 channels) and the chosen quality modes.
When a DCN system is connected to the transmitter,
(using a DCN interface module of version 01.05 or
higher), the number of channels can be automatically
set by the DCN system.
Menu Items
4B Nr. of Ch.
Bosch Security Systems | 2003-02 | 3122 475 22011en
Option
Mode:
- Standby
* - On
- Aux to All
- Test
- Slave
Option
Nr. of channels
* - Automatic: nn
- Manual: nn
Description
All channels are switched off, no signals are distributed.
Normal transmission. Input signals are distributed on the channels
as set in the Channel Quality sub-menu (4C).
The signals on the Auxiliary inputs are distributed on all channels.
A different test tone is distributed on each channel. The frequency
increases with increasing channel number. For stereo channels the
tone for left and right will also be different.
The radiator signal on the slave input is looped-through to all
radiators.
Description
The number of used channels is set automatically to the maximum
possible number of channels (depending on transmitter type and
the selected quality modes). When a DCN system is connected,
the number of channels is determined by the settings of the
DCN-system.
Set the number of used channels (the maximum number depends
on the transmitter type and the selected quality modes).
An asterix (*) is shown when the selected number is not possible
because it is higher than the maximum number of channels.
en | 28