Using The Appliance - Heinner XF-1000UV Instruction Manual

www.heinner.com

Assembly before use:
• Place the motor section (3) on a flat surface, e.g. a kitchen counter, and make sure it is standing firmly
on the four suckers underneath.
• Place the base (6) on the motor section so that the spout (5) fits in the slot on the side of the motor
section.
• Push the fruit pulp holder (2) up under the drain edge on the base so that it locks on the foot of the
motor unit tightly.
• Carefully lock the centrifuge bowl (7) onto the base.
• Be careful not to touch the sharp parts in the bottom of the centrifuge bowl.
• Make sure that the centrifuge bowl sits properly on its base, so that the gear on the bottom of the bowl
engages the gear in the base.
• Make sure that the centrifuge bowl doesn't sit too loosely on the base and that it rotates evenly.
• Place the lid (10) on the appliance so that it covers both the fruit pulp holder and the centrifuge bowl
unit. Make sure that the lid fits tightly onto the base.
• Turn the lock mechanism (4) to the vertical position and make sure that it engages the lid and locks it
fast. The lock mechanism makes a clicking sound when this is done correctly.
• Place a glass, bowl or other suitable container under the spout.
• The apparatus now ready for use.
V. USING THE APPLIANCE

Preparing fruits and vegetables for juicing:
• Always wash fruits and vegetables thorougly before juicing.
• It is not necessary to remove seeds, pits or thin peels before using the appliance.
• Fruits with thick peels such as oranges and lemons must be peeled before juicing. It is particularly
important to remove all the peel (including the pith), as even small amounts of peel can impart an unpleasant
taste to the juice.
• It is also necessary to remove large pits (such as plum and apricot pits) to avoid damaging the appliance.
• Large fruits and vegetables should be cut into pieces that can fit into the funnel (9)
1000W, 50/60 Hz, 220-240V
12