Operational Safety; Operational Guidelines; Ozone Release; Printer Location - Xerox AltaLink C81 Series User Manual

Safety

Operational Safety

Your printer and supplies were designed and tested to meet strict safety requirements. These include
safety agency examination, approval, and compliance with established environmental standards.
Your attention to the following safety guidelines helps to ensure the continued, safe operation of your
printer.
O O p p e e r r a a t t i i o o n n a a l l G G u u i i d d e e l l i i n n e e s s
• Do not remove any paper trays while the printer is printing.
• Do not open the doors when the printer is printing.
• Do not move the printer when it is printing.
• Keep hands, hair, neckties, and so on, away from the exit and feed rollers.
• Protective covers, which require tools for the removal, protect the hazard areas within the printer.
Do not remove the protective covers.
• Do not override any electrical or mechanical interlock devices.
• Do not attempt to remove paper that is jammed deeply inside the printer. Power off the printer
promptly, then contact your local Xerox representative.
• Ensure that the rear right cover is attached. To connect an interface cable, open the rear right
cover.
O O z z o o n n e e R R e e l l e e a a s s e e
This printer produces ozone during normal operation. The amount of ozone produced is dependent on
copy volume. Ozone is heavier than air and is not produced in amounts large enough to harm anyone.
Install the printer in a well-ventilated room.
For more information in the United States and Canada, go to www.xerox.com/environment. In other
markets, please contact your local Xerox representative or go to www.xerox.com/environment_europe.
P P r r i i n n t t e e r r L L o o c c a a t t i i o o n n
• Place the printer on a level, solid, non-vibrating surface with adequate strength to hold its weight.
To find the weight for your printer configuration, refer to the Specifications chapter of the User
Guide.
• Do not block or cover the slots or openings on the printer. These openings are provided for
ventilation and to prevent overheating of the printer.
• Place the printer in an area where there is an adequate space for operation and servicing.
• Place the printer in a dust-free area.
• Do not store or operate the printer in hot, cold, or humid environments.
• Do not place the printer near a heat source.
• To avoid exposure of light-sensitive components, do not place the printer in the direct sunlight.
• Do not place the printer where it is exposed to the cold air flow from an air-conditioning system.
• Do not place the printer in locations that are susceptible to vibrations.
16 Xerox ® AltaLink
User Guide
® C81XX Series Color Multifunction Printer