Husqvarna R 214C Workshop Manual page 45

3. Put the transmission belt on the hydrostatic
transmission pulley and on the belt tensioner.
4. Attach the cooling fan and the snap ring for the
cooling fan.
5. Do a check that the main belt is installed correctly on
the front pulley.
6. Attach the main belt on the engine pulley.
7. Attach the belt guide for the main belt.
8. Attach the spring.
1592 - 002 - 11.02.2021
9.9.5 To remove and attach the main belt
1. Remove the rear belt guide for the main belt.
2. Remove the main belt and attach a new belt.
3. Assemble and adjust the belt guide to the lower belt
in the engine belt pulley.
4. Measure the distance between the belt adjuster and
the belt guide. Correct distance is 17 +/- 5 mm. Do a
check of and adjust the belt adjuster.
5. Adjust the belt adjuster with the adjustment screw if
the distance is not 17 +/- 5 mm.
Repair instructions - 45