Husqvarna R 214C Workshop Manual page 39

3. Turn the adjustment nut to extend the lifting rod or
make it shorter. Extend the lifting rod to lift the rear
edge of the cover. Make the lifting rod shorter to
lower the rear edge of the cover.
4. Tighten the locknuts on the lifting rod when the
adjustment is done.
5. Do a check of the parallelism. Refer to
check of the parallelism of the cutting deck on page
11 .
6. Install the front cover.
9.6.5 To adjust the cutting height
1. Make sure that the cutting height stay is attached to
the cutting deck.
2. Put the cutting height lever in the lowest cutting
height position.
3. Remove the right footrest plate and the right side
cover. Refer to To remove the covers on page 19 .
4. Turn the adjustment nut until there is no play
between the cutting deck and the cutting height stay.
5. Do a check of the parallelism of the cutting deck.
To do a check of the parallelism of the
Refer to
cutting deck on page 11 . Adjust the parallelism if it is
To adjust the parallelism of the
necessary. Refer to
cutting deck on page 38 .
6. Do a check of the ground pressure of the cutting
To examine and adjust the ground
deck. Refer to
pressure from the cutting deck on page 38 .
1592 - 002 - 11.02.2021
9.6.6 To replace the blades
1. Remove the cutting deck. Refer to
attach the cutting deck on page 9 .
2. Lock the blade with a wooden block (A).
3. Loosen and remove the blade bolt (B), the washers
(C) and the blade (D).
4. Assemble the new blade with the bent ends in the
direction of the cutting deck.
To do a
5. Attach the blade, the washer and the bolt. Tighten
the bolt with the correct tightening torque. Refer to
Tightening torques on page 51 .
9.6.7 To disassemble the blade bearings
1. Remove the covers on the cutting deck.
2. Remove the belts.
3. Remove the screws that hold the pulley. Lock the
blade with a wooden block.
4. Remove the pulley. Use a puller if it is necessary.
C
WARNING: Incorrect blade type can cause
objects to eject from the cutting deck and
cause serious injury. Use only the blades
Technical data on page 49 .
given in
Repair instructions - 39
To remove and
B
D
A