Husqvarna R 214C Workshop Manual page 32

11. Close the clutch valve.
Note: There are 2 valves on AWD products.
12. Operate the forward and rearward pedals for 4–5
times each. Make sure the wheels start to turn
immediately.
13. Fill the transmission oil tank if it is necessary.
14. Increase the engine speed to operation rpm.
15. Operate the forward and rearward pedals for and
make sure the wheels start to turn immediately.
16. Decrease the engine speed to idle speed.
17. Fill the transmission oil tank if it is necessary.
18. Install the transmission cover.
9.5.3 Drive shafts
9.5.3.1 To remove the transmission
1. Put support below the product. Refer to
supports below the product on page 6 .
2. Remove the rear wheels. Refer to
install the wheels on page 21 .
3. Drain the oil of the transmission. Refer to
the oil in the transmission on page 37 .
4. Loosen the hose from the transmission oil tank.
Open the clamp for the suction pipe below the tank
and remove the hydraulic tank.
5. Loosen the cable and the speed control rod from the
lever.
32 - Repair instructions
6. Remove the transmission belt. Refer to
7. Remove the 5 screws that hold the rear transmission
To put
To remove and
9.5.3.2 To install the transmission
To replace
1. Assemble the rear transmission in opposite
2. Lubricate the axles with corrosion protection before
3. Fill with oil and bleed the hydraulic system. Refer to
the transmission belt on page 44 .
and lower the rear transmission.
sequence in relation to disassemble. Refer to
remove the transmission on page 32 .
attaching the wheels.
Note: The spacer sleeves in the wheels have
different lengths. Left: 36.3 mm + washer. Right:
45.5 mm, no washer.
To bleed the drive system on page 31 .
To remove
To
1592 - 002 - 11.02.2021