Husqvarna R 214C Workshop Manual page 29

9.3.2 Electrical diagram R 214C
9.3.3 To replace the main fuse
A blown fuse is identified by a burned connector.
1. Open the engine cover. The main fuse is in a holder
in front of the battery.
2. Pull the fuse from the holder.
3. Replace the blown fuse with a new fuse of the same
Technical data on page 49 .
type. Refer to
4. Attach the covers.
If the main fuse blows again a short period after you
replace it, there is a short circuit. Repair the short circuit
before you operate the product again.
1592 - 002 - 11.02.2021
9.3.4 To remove and install the operator presence
control (OPC)
1. Lift the seat.
2. Remove the screw that hold the spring and spring
washer.
3. Disconnect the cable connector from the OPC.
4. Press in the fasteners and remove the OPC from the
holder.
5. Install in the opposite sequence.
Repair instructions - 29