Husqvarna R 214C Workshop Manual page 44

9.9.3 To remove the transmission belt
1. Lift up the cutting deck.
2. Remove the transmission cover. Refer to
the transmission cover on page 19 .
3. Remove the snap ring and remove the cooling fan.
4. Disengage the spring on the belt tensioner.
5. Remove the transmission belt from the hydrostatic
transmission pulley with a screwdriver and a wrench.
6. Remove the engine pulley covers on the left and
right side of the product.
44 - Repair instructions
7. Remove the belt guide for the main belt.
To remove
8. Pull the main belt from the engine pulley and put it to
the side.
9. Pull the transmission belt off the engine pulley and
move it below the engine belt pulley.
10. Pull out the transmission belt through the opening
below the pivot bearing and in the direction of the
hydrostatic transmission pulley.
9.9.4 To install the transmission belt
1. Pull the transmission belt through the opening below
the pivot bearing and in the direction of the
hydrostatic transmission pulley.
2. Pull the transmission belt below the engine belt
pulley and put it on the engine belt pulley.
1592 - 002 - 11.02.2021