Fingerprint Reader Board - HP EliteBook 835 G8 Maintenance And Service Manual

4. Remove the board from the computer (5).
Reverse this procedure to install the USB board.

Fingerprint reader board

To remove the fingerprint reader board, use this procedure and illustration.
Table 6-7 Fingerprint reader board description and part number
Description
Fingerprint reader board
Fingerprint reader board cable (included in Cable Kit)
Fingerprint reader board bracket (included in Bracket Kit)
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the fingerprint reader board:
1. Disconnect the cable from the ZIF connector on the fingerprint reader board (1).
2. Remove the Phillips M2.0 × 2.0 screw (2) that secures the fingerprint reader bracket to the computer,
and then remove the bracket (3).
Preparation for disassembly on page
Bottom cover on page
Battery on page 42).
32).
Component replacement procedures
Spare part number
M36397-001
M08526-001
M08556-001
32).
49